Installation

View of meter (cut away) with wire in U-shaped channel.

View of spark plug wire with pickup wire wrapped around 4 times.

Operation

FUNCTION OPERATION
Push and release mode control in order to toggle between Hour Meter, Tachometer and Job Timer.

HOUR METER
Indicated by TOT TIME on display (is non-resettable).

TACHOMETER
Upon entering this function you will see P1, P2, or P3 for 3 seconds on the right hand side of the display. This is the current programmed firing pattern. To access MAXTACH (highest engine RPM) be in the RPM mode and hold mode control down for at least 3 seconds; to erase the high RPM continue holding down for at least 9 seconds (will see 0000). To change the firing pattern, be in the RPM mode and hold mode control down for more than 10 seconds; release mode control on desired firing pattern (P1, P2, or P3).

JOB TIMER
To reset to zero, push and release the mode control until you are in the Job Time mode. Depress and hold the mode control for 3 seconds (time will clear to 0.0).