View of meter (cut away) with wire in U-shaped channel.

View of spark plug wire with pickup wire wrapped around 4 times.

Operating Instructions

Push and release mode control to toggle between Hour Meter, Tachometer, Job Timer, and Service Alarm (SVC TIME, SVC SET).

Hour Meter - Indicated by "TOT TIME" on display (non-resettable accumulated running hours.)

Tachometer - Upon entering this function, you will see "P1", "P2", or "P3" for 3 seconds on the right-hand side of the display. This is the current programmed firing pattern. To access MAXTACH (highest engine RPM), be in the RPM mode and hold the mode button down for at least three seconds. To erase the high RPM, continue holding down for at least 9 seconds (will see 0000). To change the firing pattern, be in the RPM mode and hold the mode button down for more than 10 seconds, then release the button on the desired firing pattern ("P1", "P2", or"P3").

Job Timer - To view the JOB TIME, push and release the mode button until the display reads "JOB TIME". To reset to zero, depress the mode button for three seconds (time will clear to 0.0)

- Click Here to Order -